AK Camper Factory visit Pirelli seal replacement
#11
Posted 07 July 2018 - 12:47 PM
#12
Posted 27 October 2018 - 11:36 PM
Very glad I found this thread. I posted a new one but this is an excellent thread. I just got in the mail 60 ft. of Pirelli for the inside of the trailer. I noticed the old Pirelli did not go to the four corners but the sides and ends all stopped about 1 inch from each corner. Shouldn't they go to the corners and butt against each other? This way, there's no gap in each corner??
I pulled the old gasket off so now I'm on "holding pattern" until I can find out about the corners so if someone could reply asap, I would greatly appreciate it. Tomorrow is suppose to be a beautiful day and hope to install them after church while the weather is still nice.
Another question that came up when I was reading this thread was the outside gasket. I didn't even think about that but now that its been brought up, where do I purchase those at? Alaskan Camper.com??
Thanks so much,
Joe
1972 NCO Alaskan 10'
#14
Posted 28 October 2018 - 05:28 AM
I am haunted by waters
#15
Posted 28 October 2018 - 10:18 PM
I think you're right Wandering Sagebrush. I'm going to wait and talk to Brain tomorrow. Wish I could have done it today but that's the way it goes sometimes.
1972 NCO Alaskan 10'
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users