1 reply to this topic

[lactic]

I picked up an eMylo single channel remote control switch to activate the rear floods on my Fleet. Anyone have experience wiring one of these in? I have identified the positive and negative lines going to the back of the existing switch but not sure how to splice in the remote relay in series so the existing switch acts as a master kill switch to the floods.

 

Thanks

Attached Thumbnails

• 

Edited by lactic, 17 June 2018 - 09:23 PM.

[mhskog]

I believe if you wanted to wire it as a master kill switch you would wire it between fuse box and the existing switch. That would kill power to the whole circuit. To make the lights go on both the remote and the switch would have to be on.