SloGoin''s Albums and Images

This is a tarp awning I made after installing an awning rail in the place of where a previous awning had been.

Replacing the old base cabinets with finished birch laminate plywood. Made brackets from aluminum angle stock

The door had a crease in the base. The window had slid down the window frame while I brought it home. I straightened the door and door frame and installed a new vertical sliding tinted door window

The original wiring was poorly done. The plug was located on the Rt side and was used as a junction for the house battery. Wire was relocated, a battery wire and power blocks installed as well as an optional access for future solar install.

Old flooring was abuse, curling up on the edges, and very dirty.

an unseen, previously repaired, undisclosed, damaged right rear corner. Welded by a certified welder, former Navy submarine hull technician and local welding instructor.

This is what I brought home. Very poorly maintained and dirty. I was to discover that it required much more work than met the eye.

Cleaned and removed the old caulk, removed all the screws and inspected the washers and replaced those that needed replacing. Removed and resealed the roof edge screws. Resealed all roof vents.

removal, repair and re installing the siding, removing and replacing decals (thanks Stan for the decals)