12 replies to this topic

[DSD277]

Selling my ‘15 Fleet shell w/ custom riser for uses with 2^nd gen Colorados. Without the riser, fits Tacomas .
Camper has
camper jacks
8’ Fiamma F45S awning
Fantastic fan
160 solar panel , and split charger controller (75% to house battery, 25% to vehicle)
Group 34 Optima battery
Propane furnace and 2 burner cooktop
4 exterior gas struts
2 12v sockets, 1 dual USB socket
Added a interior LED lamp with switch to door to illuminate inside shell without climbing in
Spare backup camera mounted to riser
The custom forkliftable riser frame to elevate camper to clear sides of truck bed, rear folding step for easy access to camper when top is down or up. ( with top down, lower step is at a level for easy transition from standing to your knees in the shell. Upper step for stepping up into the shell when top is up. Designed for my height of 6’1 and legs with 30” inseam)
Thread on riser and step here:
https://www.wanderth...and-other-mods/
Camper fits a Tacoma, riser is only needed for the Colorado, either 5 or 6' bed.


located near Los Angeles in Arcadia



Dave
dsd277@sbcglobal.net

Attached Thumbnails

• 
• 
• 

Edited by DSD277, 04 August 2022 - 07:28 PM.

[DSD277]

More pics of the interior. I also have a steel dolly with swivel casters that goes with it

Attached Thumbnails

• 
• 
• 
• 

[DSD277]

Exterior pics

Attached Thumbnails

• 
• 

[Pax2525]

Got a pic of the riser?

[DSD277]

There is a pic of it in the link , along with the step.

The riser works with and without the tailgate in place

 

Attached Thumbnails

• 
• 

[DSD277]

There is also a steel dolly w/ aligning tabs that goes with the package. 5" HD swivel casters w/brakes. Needs painting since it was put into use right after being made. Surface rust only

Attached Thumbnails

• 

[ogre]

How much for camper w/o riser have a Tacoma?

[DSD277]

PM sent

[DSD277]

I haven't been updating this listing due to health reasons.
In the mean time, I have mounted the camper onto a different truck. It is now on a 2019 Ford F-150 Supercab using the same riser adding 1 bar in the front of the bed. I'll be adding pics later.

[DSD277]

Photos of the Fleet on the F-150. Though it looks tight, there is just under 3" of clearance between the underside of the cab-over and the cab. Also in the method of the base installation, the camper can only move a quarter inch laterally, so stays centered  in the bed

Attached Thumbnails

• 
• 
• 
•