55 replies to this topic

[Sleddog]

Then a piece of 1/4 inch floor underlayment.

Attached Thumbnails

• 

[Sleddog]

And finally a piece of vinyl carpet flooring and trim. The floor layers are not glued or otherwise attached. The trim holds everything in place.

Attached Thumbnails

• 

[Sleddog]

I cut an access to the new driver side storage area and reused a sliding door from the original cabinets.

Attached Thumbnails

• 

[Sleddog]

I also cut another access to the new passenger side storage. This one is uncovered for now, I'll take care of it when I finish the wrap around couch.

Attached Thumbnails

• 

[Sleddog]

To finish up the outside of the wider floor pack, I used a 2x6 on each side to firm up the base and used three pieces of 2x2 per side to frame up from there. I covered the framing with metal from a roll of metal roof flashing I already had. I forgot to take photos of the framing before covering it with metal.

Attached Thumbnails

• 

[Sleddog]

Next came the trim, I just used some leftover metal roofing trim I had laying around.

Attached Thumbnails

• 

[Sleddog]

I took the time to close off the end of the new storage area so nothing would end up in the truck bed and left an opening for getting to the turnbuckles.

Attached Thumbnails

• 

[Sleddog]

And a final coat of paint.

Attached Thumbnails

• 

[Sleddog]

.

Attached Thumbnails

• 

[Sleddog]

.

Attached Thumbnails

•