2 replies to this topic

[joseph.hinker]

Hello WandertheWest,

 

I am rebuilding my FWC and I will be attaching the new lift panels to the roof soon. The pieces of aluminum that runs east/west on the front and back of the roof .

 

 

 

The front piece is about an inch 

 

 

the Back piece is about an inch and a half

 

I was hoping someone would be able to measure their camper to let me know if the distance should be the same for the front and back or is my roof the correct way.

 

( if your camper is already complete the measurement would still be helpful)

thanks - 

[PokyBro]

I would recommend calling Marty at All Terrain Campers as your best best bet. He will know those measurements accurately, and you can have a discussion to make sure you understand. Otherwise, do you have the original holes you could use?

 

Poky

[joseph.hinker]

I would recommend calling Marty at All Terrain Campers as your best best bet. He will know those measurements accurately, and you can have a discussion to make sure you understand. Otherwise, do you have the original holes you could use?

 

Poky

 

Calling ATC is probably going to be the best thing to do. There is holes there but I am not sure if the pervious owner changed anything around. I am going to take a closer look at it tomorrow and see.