Question: should I cut the wires after they come into the roof and then splice in a section that I can run behind the pop-up panel and then down towards the battery? I want the controller next to the battery and would prefer the monitor on the drivers side near the thermostat but might be easier to keep it closer to the battery on the passenger side. I don't know where to run the wires, unsure if I should remove paneling, or need to drill some holes.
Any advice or tips are greatly appreciated. I have seen an older posts of Vic's with the controllers, shunt, etc mounted to a plywood board which I think I will also do.
Best,
Ryan 45A1CCDC-4646-42C3-B8D2-B851D8869F74.jpeg 94.25K 17 downloads A294BCAC-36CE-4CC7-B94A-3778243A7B79.jpeg 81.28K 18 downloads A0998BFA-9D16-41BB-A201-49701DC006F1.jpeg 100.85K 15 downloads 43822D10-B784-40A6-9AF0-79C4A5B278BC.jpeg 106.5K 15 downloads
Edited by Ryan D, 27 June 2021 - 10:53 PM.