Rear bumper step
#1
Posted 16 November 2007 - 03:11 AM
So here's some pictures of my simple mod to the rear bumper of my Chevy truck. My truck is a 2wd half ton, so the bumper is probably closer to the ground than some of 4wd, lifted trucks, that are used to haul these FWC/ATC campers. When unloaded, the step down portion of the bumper is about 19 1/2" above the ground and when loaded with the camper it sinks down about 2 1/2" to around 17" above ground. I also added a couple strips of anti skid tape to the top of the bumper because I noticed we sometimes step on that too and when wet it can be slippery. I offset the aluminum step a little toward the passenger side because the Grandby door is offset to the passenger side several inches. Haven't used it camping yet.
Buzz
2017 Ram 3500 6.4L gas SRW, CC, 2wd, 8' bed
2007 FWC Grandby--Sold
2015 Hallmark Ute XL
#2
Posted 16 November 2007 - 04:27 AM
#3
Posted 16 November 2007 - 04:44 AM
Buzz
2017 Ram 3500 6.4L gas SRW, CC, 2wd, 8' bed
2007 FWC Grandby--Sold
2015 Hallmark Ute XL
#4
Posted 16 November 2007 - 06:29 AM
#5
Posted 16 November 2007 - 05:22 PM
Nice simple solution, good job.
Linda,
Welcome to the forum.
#6
Posted 16 November 2007 - 07:39 PM
Welcome to the forum Linda.
Buzz
2017 Ram 3500 6.4L gas SRW, CC, 2wd, 8' bed
2007 FWC Grandby--Sold
2015 Hallmark Ute XL
#7
Posted 16 November 2007 - 10:16 PM
Buzz look at my photo in the gallery i'll try to post it Stan said it was discontinued here is a web site http://www.e-zstep.com two steps into hitch.
Mines similar to that. I believe it was a company out of colorado that made it. No markings on mine.
Craig K6JGV_________________________ 2004 2500 CTD 4X4 FWC HAWK 1960 CJ5
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users