jacks

I am looking for suggestions for a campground between Jacksonville, FL and Disney in early November. I've done a little research and am looking at the Salt Springs area or possibly Daytona Beach area. We prefer sewer hookups. We would love to be on/near some body of water and no more than 2...

Had to lower jacks manual this weekend and now don't have any jacks that work. Went through all the re-set that lippert has on website but still no jacks move. Checked fuse's by the pump, 3 amp and 15 amp and both are good,is there a hidden fuse or breaker for this system on RV somewhere else...

We have a 2004 Sunova and the Qwikee Level Best jacks are leaking, especially when they are down. I’ve taken them to a hydraulic shop and they say they are not serviceable. I called Lippert (the now own Qwickee) and Winnebago who both say they are not serviceable and would need to be replaced...

In our previous trailers I was always able to tweak the right to left leveling with a few squeezes of my cordless drill. Just enough to keep the interior doors from closing. I don’t seem to be able to do that with the power jacks on our new Rockwood. Any ideas or work-arounds for that?

I have a coachman 320BHDSLE that we bought new in 2016. I purchased 4 libra 7500lb stabilizing jacks to help with the bounce in the trailer. I was planning on placing two on each side with one in front and one behind the wheels. Does this make sense to use them in conjunction with the factory...

Has anyone made the conversion from single power jacks on a 5ver to independent power jacks? It appears to me that I must remove the tailing leg and cross shaft and replace it with a complete power leg, gear box, and drive motor power plus switch harness. Anyone have any links or write ups...

hello all, I have a 2019 Cherokee gray wolf 20RDSE. it came with no stabilizer jacks so I got some off amazon and their is no way they will mount up to the "I" beam frame, the holes on the jacks will not allow a spot on the frame, way off, so can anyone take a look at what brand of jacks they...

We took our 2017 FR 201BHXL out this weekend, the rear stabilizer jacks where acting odd before we left our house retracting very slow after I taped on the motor. They did not extend when we where setting up at our camp site. So spend the weekend without them. Tried them again when we got back...

Good morning seems all my electrical controls to the rear stabilizer jacks arent working. I can manually crank them up and down without issues Checking the up/down switch at the rear of the camper there is no 12V on any cable. I have a 2019 sprinter campfire 5th wheel 32 FT The stabilizer is a...

I have a 2001geogetown 325s. Best out coach. Well went to let it down of the lever Jack's and the back one went right up the front ones didn't budge . Try everything I knew to do. I finally took the bleeder screw out of each on and push them up with a jack. Alot of fluid came out. Now what do I...

Four Excellent Rieco Titan Jacks-Mechanical $600. Like brand new. I used the jacks only 2 times and I am selling them because I have set up a different system to remove my Alaskan camper off and on my truck. Picture below is jacks on the camper before the newer system rebuild. I purchased...

Another issue with my little used (2500 mi) 2013 Vista 30T. Have an issue with jacks giving an error when retracting or leveling. Had service look at it and they replaced solenoid, did not stop problem. But when you tap on the pump motor with a hammer a few times it will work. Then the next day...

Has anyone used the Snap Pads on their leveling jacks? Did they work? Do you leave them on? Are you happy with them? Any issues? Thanks,

Been on the road for six months and everything worked fine. Got to our spring work site and ran the bedroom slide out a few inches to get in the dresser and then back in. Worked fine. Moved to our campsite and leveled her just fine, all jacks extending and/or retracting as needed. Once level...

I've been trying to figure out how to manually retract the jacks (one of which leaks) and became confused as to which motor etc that we have. Turns out that the manual we were given was dated August 2011 revised May 2013. The confusion ended today when Randy from Equalizer today emailed me a...

I have some work to do on my 5ers landing gear and would like ideas and thoughts on how to support the 5er pin without connecting the 5er to my TV. Since I work slow it will take several days to complete my project and I don't want the TV tied up that long. I'm assuming a 4x4 or 6x6 post...