Jump to content


Photo
- - - - -

cast iron: avoiding rust


  • Please log in to reply
19 replies to this topic

#11 Casa Escarlata Robles Too

Casa Escarlata Robles Too

    C'est la vie

  • Site Team
  • 9,296 posts
  • Locationmonterey bay area

Posted 25 March 2016 - 06:17 PM

Bseek,saw this in this mornings paper.Might help answer some questions.

Frank

 

 

IMG_1283.jpg


  • 0

2002 Tundra AC TRD 4WD Limited 2009 ATC Bobcat loaded http://sharychic.blogspot.com/


#12 Bill D

Bill D

    Senior Member

  • Members
  • 981 posts
  • LocationEdmonton, Alberta, Canada

Posted 26 March 2016 - 04:02 AM

I'm inclined to agree with Carl.  Season it.  If you wash it, avoid using soap.  It's not that big of a deal if you use soap, sometimes it's necessary to save time, but reheat it immediately to dry and wipe it with a light oil.  Crisco is best.

 

When I go to use the pan again, I usually wipe it with a paper towel as it's heating to remove any rust that may have built up during storage.  It's usually minimal.

 

It's pretty easy to restore a cast iron pan if it gets a bit of rust.  Sandpaper or steel wool works well and sand works if you don't have anything else.

 

I know you were looking for magic storage secrets, but there really isn't any.  Just store it seasoned.

 

If you really hate rust, here is a picture of some rust removal I did on a test piece of sheet metal.  Personally I'd rather eat rust ;-)

 

polish_brightener.jpg

 

 


  • 0

#13 Waist High

Waist High

    Newbie

  • Members
  • Pip
  • 5 posts
  • LocationSC CA

Posted 21 April 2016 - 04:12 AM

If you wish to use none of the above- simply rinse pan very well, dry with towel, and flip the pan over and place on an open flame for about a minute. Then allow time to cool.

 

I camp/pack pretty light. I can't imagine carrying all those items to keep a pan rust free. A fire/ flame will always be at my destination!


  • 0

#14 Rdy2Roam

Rdy2Roam

    Senior Member

  • Members
  • 121 posts
  • Locationflorida

Posted 21 April 2016 - 09:10 PM

Cast iron is all I use, been using it for years. Just wipe it out and use hemp oil to coat it. After well seasoned I only coat it once in a while, but I use it every day though.  If you use water to clean it definitely coat it with oil once dry. Nothing better than cast iron.


  • 0

#15 Threerun

Threerun

    Member

  • Members
  • PipPip
  • 17 posts
  • LocationLost in Montana *recalculating*

Posted 22 April 2016 - 03:23 AM

I just wipe it with lard. Unlike oil it will stay firm and adhere to the iron. We used to butcher hogs and all the iron kettles got a coating of lard before being stored away. 


  • 0

#16 Rusty

Rusty

    Senior Member

  • Members
  • 931 posts
  • LocationPort Angeles, Washington

Posted 18 May 2016 - 08:16 PM

seasoned properly you won't have to use any soap on it as has been noted.  Heating the pan after rinsing out to expand the pores in the iron then apply a quick spray of Pam while hot, allow to cool, wipe out excess and put it away....no rust

 

We use a series of 4 different cast iron frying pans at home for just about everything.  everybody knows the drill and all the pans are rinsed out after use allowed to cool on the stove top with a quick shot of pam...

 

I put them away the next morning in my "dish put away" ritual. 

 

better than any non-stick pan by a longshot...and your grandchildren will inherit them....a far cry from today's pots and pans


  • 0

2003 Ford 250 Superduty Crew.... 7.3L PowerStroke diesel 1970 10" NCO Alaskan Firestone airbags pulling a 18' Silver Streak runabout


#17 Bluedog

Bluedog

    Advanced Member

  • Members
  • PipPipPip
  • 45 posts

Posted 19 May 2016 - 12:45 AM

Cook bacon more often, that will keep the rust away ;)


  • 1

#18 BILL98388

BILL98388

    Senior Member

  • Members
  • 135 posts
  • LocationWestern Washington

Posted 06 June 2016 - 05:14 AM

Disclaimer: the author is my spouse...  ;-)

 

Good information on caring for cast iron cookware.

 

http://hubpages.com/...-Cast-Iron-Pans

 

Most of the recipes in her blog have been tested in our kitchen, ummm good!

 

Bill (and Linda)


  • 1

Bill

2014 Grandby on 2015 4x4 Tundra (8-ft bed)

Steilacoom, WA


#19 Bseek

Bseek

    Gypsy Feet

  • Members
  • 448 posts
  • LocationSonora, Ca Sierra Foothills

Posted 06 June 2016 - 05:13 PM

Well done Linda.

 

Since I am the original poster I will say that I swapped out the brand new Lodge pre-seasoned skillet in the Bobcat with an antique Griswold I found at a yard sale. No more problems. The Lodge had the pebbly texture which I thought would be better, but as the above article says, go for the smooth!


  • 0
Subaru Outback Gypsy Wagon
2013 Toyota Tacoma DCLB : 2015 ATC Bobcat shell
By the way, it's Brenda   https://sierrashadow.wordpress.com/

 


#20 takesiteasy

takesiteasy

    Senior Member

  • Members
  • 2,588 posts
  • LocationMinnesota

Posted 07 June 2016 - 01:36 AM

Well done Linda.

 

Since I am the original poster I will say that I swapped out the brand new Lodge pre-seasoned skillet in the Bobcat with an antique Griswold I found at a yard sale. No more problems. The Lodge had the pebbly texture which I thought would be better, but as the above article says, go for the smooth!

 

My son gave me an old Griswold skillet for Christmas. It's like new but for the patina of years of use. I cook with it almost every day- love it.


  • 0
2011 Tacoma AC TRD
ATC Custom Shell

travelswithrockythedog.blogspot.com




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users