Hawk rear floodlights
Started by
Stormfishing
, Jan 17 2020 05:16 AM
1 reply to this topic
#1
Posted 17 January 2020 - 05:16 AM
Does anyone have the measurements for where to drill for rear floodlights on a 2017 Hawk. I know it came pre wired.
#2
Posted 17 January 2020 - 07:26 PM
On both campers that I took the inner walls apart on, and installed flood lights on, there is a 1/4" hole through a thicker piece of U-channel high up on the back wall. The power wire looks like it was inserted through the hole,and then duct-taped to the outside of the U-channel before the siding was installed. I extracted the wire and then drilled a tiny pilot hole from the inside before making a bigger hole from the outside.
In short, finding the exact spot will be very hard to do, even if you have measurements.
I'd peel off the inside panels if doing this.
2015 Silverado 3500 crew cab 8' bed Diesel
2012 ATC Puma Shell build - https://www.wanderth...012-puma-build/
Power considerations thread - https://www.wanderth...e-power-scotty/
Building out an electrical system - So, you want to setup a good electrical system in your camper? - Electrical, Charging, Solar, Batteries and Generators - Wander the West
2012 ATC Puma Shell build - https://www.wanderth...012-puma-build/
Power considerations thread - https://www.wanderth...e-power-scotty/
Building out an electrical system - So, you want to setup a good electrical system in your camper? - Electrical, Charging, Solar, Batteries and Generators - Wander the West
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users