Recently picked up a 2006 FWC Eagle. It has an inverter and the IOTA distribution panel. The original owner I learned did not use a camper battery but drew power directly from his truck battery. I would like to add a camper battery with seperator. I had assumed the distribution panel would supply a fuse location for this however I am wrong.
My question is best way to wire in my battery (I need to also wire my truck).
After I wire in the seperator, the leads that then go to the camper would I assume be wired into the female that I install on the bed of the truck.
From this point I'm a bit confused as to where that cable goes.
There is no fuse labelled battery. If the male plug and wire of the camper goes to the panel (as it must) - I assume it is the 12V input wire. Given that, do I just splice this wire to add my battery? This leaves no fuse between the 2nd battery and the first. I could splice and add an inline fuse. Or I could use the "not used" first fuse spot to add the battery. What size fuse - 50Amp? Currently there is only lights, fan, and fridge.
What is the usual setup? Thanx in advance