Upon powering my victron MPPT 100/15, the load output setting is "battery life". Is this the ideal setting given I don't have anything plugged into the load receivers on the MPPT. Just running the two 6 volt AGMs off the 160 Watt Solar Panel.
MPPT Charge Controller Settings
#1
Posted 26 August 2022 - 03:59 AM
#2
Posted 30 August 2022 - 02:56 AM
If you are not using the Load terminal, battery life setting doesn't matter. It's not easy to use the Load terminal in an FWC - you need to disconnect the positive wire from the battery to the FWC fuse block switch and instead run a wire from the Load terminal to the fuse block switch. And I think you also need to rewire the 120V-12V Iota converter. If you are able to pull this off, the Victron MPPT will protect your battery by disconnecting the load (all your 12 V devices) when the battery reaches a set low state of charge, 50%, 30%, etc.
2015 Fleet on 2019 Ranger
#3
Posted 30 August 2022 - 08:19 PM
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users