8 replies to this topic

[markile]

Quick question,  Can anyone tell me the standard width (between the wheel wells) of an ATC Bobcat?

 

TIA

[Wandering Sagebrush]

My Bobcat on the Ranger appears to be 50.5". I didn't have anyone to hold the tape on the far side of the truck, so it could be a bit off.

[DavidGraves]

Howdy

 

I don't know the answer but Sage, you may have misread the question ?

 

Between the wheel wells...inner fenders...is your 50.5 measure for at the tailgate opening ?

 

Or maybe I misread it....happens all the time  !

 

David Graves

[Casa Escarlata Robles Too]

I just measured my Bobcat it's 51 1/4" measured across the rear of the camper. Between the wheel wells.

With a total outside measurement  of 72 1/2" width.

Frank

[markile]

Hi all, I've been talking with an owner of a 2010 Bobcat that was on a 2006 Tacoma with an approximately 42" clearance between the wheel wells.  Thanks for all your input!

[Casa Escarlata Robles Too]

I think ATC adjusts the "between the wheel well" measurement per truck type.

My 09 Bobcat was first made for the Ford Ranger we had then mounted on a 1st gen Tundra.

[Casa Escarlata Robles Too]

Markile, I guess I was to quick to measure.

Just did another and it's about 41". The 51 1/4 is the "outside tailgate width.

Sorry to misinform.

Frank

[Wandering Sagebrush]

Hi all, I've been talking with an owner of a 2010 Bobcat that was on a 2006 Tacoma with an approximately 42" clearance between the wheel wells.  Thanks for all your input!

I just realized I measured at the front, but above the wheel wells. With the camper on the truck, I can't get to the area between the wells. Apologies!!!

[markile]

Markile, I guess I was to quick to measure.

Just did another and it's about 41". The 51 1/4 is the "outside tailgate width.

Sorry to misinform.

Frank

Outstanding!