Here's the fishing rod holder I put together for my trout rods in my FWC-Hawk. It will be held on via screws and wingnuts in the storage holders (so clamp is only temporary). Have not used it yet, but I had a similar setup in my last Pop-Up (Northstar TC650) which worked well.
#1
Posted 04 July 2018 - 05:54 PM
#2
Posted 04 July 2018 - 07:50 PM
I am haunted by waters
#3
Posted 07 July 2018 - 02:22 AM
SD_Beaker: I like that. My rod holder/case is on the exteriore under the overhang. 4" PVC, but could have went as large as 6". Held on by SS footman loops and SS hose clamps.
2016 FWC Hawk Shell
2011 Chev Silverado 1500 4x4 ext cab
2018 Chev Silverado 2500 4x4 ext cab
Super Springs
Helwig Sway Bar
#4
Posted 15 August 2018 - 03:38 PM
SD_Beaker: I like that. My rod holder/case is on the exteriore under the overhang. 4" PVC, but could have went as large as 6". Held on by SS footman loops and SS hose clamps.
Trapper Mike:
Finally getting around to installing a 6" conduit storage tube under the roof of my Hawk. Where did you put the footman loops? Are the loops against the front panel just below the corner where it meets the roof? Anything you would have done differently??
Thanks!!
2019 Tundra 2019 Panther Shell
#5
Posted 15 August 2018 - 07:58 PM
Ronin,
The footman loops are tight to the corner intersection of the overhang and front wall, but are attached to the metal on the vertical surface of the front wall. There is a beam behind there and just used stainless strews. So far so good and everything is holding up well.
Mike
2016 FWC Hawk Shell
2011 Chev Silverado 1500 4x4 ext cab
2018 Chev Silverado 2500 4x4 ext cab
Super Springs
Helwig Sway Bar
#7
Posted 16 August 2018 - 04:01 PM
Ronin,
The footman loops are tight to the corner intersection of the overhang and front wall, but are attached to the metal on the vertical surface of the front wall. There is a beam behind there and just used stainless strews. So far so good and everything is holding up well.
Mike
Thanks!! I should receive my conduit carrier kit today. The Buyers 6"conduit kit price was recently reduced to $38.00 so I decided to go for it. Just one of those "I'll get around to it someday mods".
2019 Tundra 2019 Panther Shell
Also tagged with one or more of these keywords: Hawk
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users