Jump to content


Photo
- - - - -

1978 FWC New Owner


  • Please log in to reply
192 replies to this topic

#131 longhorn1

longhorn1

    Ouch, that stings!

  • Members
  • 2,826 posts
  • LocationCarmel, Indiana

Posted 11 December 2017 - 10:21 PM

Maybe you fabricate a piece of metal shield that you mount to prevent problems, easy on easyoff
  • 0

http://texaslonghorns01.blogspot.com/

 

Ford F-250 Long bed, 2014 Grandby

 


#132 PokyBro

PokyBro

    Senior Member

  • Members
  • 467 posts
  • LocationLas Vegas, Nevada

Posted 12 December 2017 - 03:35 AM

Porter, I had a Hallmark camper a couple summers ago, that had the heater vent out the back. The door didn’t swing in front of it, but I inadvertently set a wood step ladder next to the vent. I was inside when I smelled smoke, then quickly realized what the cause was. Moral of the story is it doesn’t take long for hot exhaust from a furnace to cause a problem. I’d strongly encourage making the change proactively.

Poky
  • 0

1999 F250 crew cab SRW, 7.3 Powerstroke TD

1981 Grandby shortened to a Hawk

Build thread / https://www.wanderth...by-into-a-hawk/

 


#133 Portercassidy

Portercassidy

    Senior Member

  • Members
  • 148 posts
  • LocationColorado Plateau Metro

Posted 12 December 2017 - 09:57 PM

IMG_0179.JPG

Flipped the door. I will be more relaxed knowing that the door cannot be left open.

I now know which butyl tape is worse to scrap off, old crusty butyl or new gooey butyl. Brand new tape is worse to remove.

Edited by Portercassidy, 12 December 2017 - 10:01 PM.

  • 0

#134 Portercassidy

Portercassidy

    Senior Member

  • Members
  • 148 posts
  • LocationColorado Plateau Metro

Posted 12 December 2017 - 10:02 PM

IMG_0180.JPG

A hair dryer goes a long ways installing the trim. I did not figure that out until after my fingers were super sore.
  • 0

#135 shellback

shellback

    Senior Member

  • Members
  • 336 posts
  • LocationWagontown,PA

Posted 12 December 2017 - 11:11 PM

attachicon.gifIMG_0179.JPG

Flipped the door. I will be more relaxed knowing that the door cannot be left open.

I now know which butyl tape is worse to scrap off, old crusty butyl or new gooey butyl. Brand new tape is worse to remove.

Curious how you flipped the door. Did you just turn it upside down so the hinges were on the other side? I made a mistake on my door flipping it,  then realized the sliding window would allow water to run inside. The upper window should be to the outside of the lower window. You are making great progress on the project! 


  • 0

#136 Portercassidy

Portercassidy

    Senior Member

  • Members
  • 148 posts
  • LocationColorado Plateau Metro

Posted 13 December 2017 - 12:28 AM

Curious how you flipped the door. Did you just turn it upside down so the hinges were on the other side? I made a mistake on my door flipping it,  then realized the sliding window would allow water to run inside. The upper window should be to the outside of the lower window. You are making great progress on the project!


I flipped the whole door frame. Luckily for me, I put the window in upside down the first time, so my mistake worked out in my favor this time.
  • 0

#137 Portercassidy

Portercassidy

    Senior Member

  • Members
  • 148 posts
  • LocationColorado Plateau Metro

Posted 13 December 2017 - 05:25 PM

IMG_0181.JPG

Front turned out pretty good. Not finished quite yet.
  • 0

#138 Portercassidy

Portercassidy

    Senior Member

  • Members
  • 148 posts
  • LocationColorado Plateau Metro

Posted 13 December 2017 - 05:25 PM

IMG_0182.JPG

Looking pretty good.
  • 0

#139 Portercassidy

Portercassidy

    Senior Member

  • Members
  • 148 posts
  • LocationColorado Plateau Metro

Posted 13 December 2017 - 05:46 PM

IMG_0184.JPG

Coolest Part. It barely fits.
  • 0

#140 Portercassidy

Portercassidy

    Senior Member

  • Members
  • 148 posts
  • LocationColorado Plateau Metro

Posted 13 December 2017 - 06:38 PM

IMG_0185.JPG

MX hauler works as a pretty good step.
  • 0




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users