58 replies to this topic

[LuckyDan]

Brandon, I've had success running aluminum wire through my wire feed welder by changing out the stainless steel liner for a nylon one and switching the shielding gas. Cheaper than a MIG spool gun. Easier to get into tight places in your framework too. Best of luck with your re-ferb.

[chnlisle]

I have a pencil.

[Brandon]

I have a pencil.

Congrats..

me no comprendo

Been working on some other projects, on hold till I can find some dinero...

Flippin reduced work schedule and no OT

[Casa Escarlata Robles Too]

Congrats..

me no comprendo

Been working on some other projects, on hold till I can find some dinero...

Flippin reduced work schedule and no OT

brandon,what have you been doing to the hawk?haven't seen any up dates.remember i can only save that spot in yellowstone so long.get busy we all want to see some work. frank

[Brandon]

brandon,what have you been doing to the hawk?haven't seen any up dates.remember i can only save that spot in yellowstone so long.get busy we all want to see some work. frank

Funds went to ErinMillerPhotorgraphy for the moment..

Been working on the Scout, and other people vehicles to help offset the furlough pay cut which was just stopped - woohoo!

I did buy a spool gun for my welder (actually a ready welder, can run off my welder or car batteries far from civilization ).

What is the dimensions of your upper bed?

Thanks..

[Casa Escarlata Robles Too]

Funds went to ErinMillerPhotorgraphy for the moment..

Been working on the Scout, and other people vehicles to help offset the furlough pay cut which was just stopped - woohoo!

I did buy a spool gun for my welder (actually a ready welder, can run off my welder or car batteries far from civilization ).

What is the dimensions of your upper bed?

Thanks..

glad to hear about the furlough days being a thing of the past.the cab over bed is 70"x48",the dinette into bed is 5'4"x21" or an extra 9"of hard part of the camper.get busy. frank

[Brandon]

glad to hear about the furlough days being a thing of the past.the cab over bed is 70"x48",the dinette into bed is 5'4"x21" or an extra 9"of hard part of the camper.get busy. frank

Thanks, and the furlough stopping was very short lived. Hours actually - back to part time employee

Did a complete front and rear suspension/axles swap in two days for a guy. Couple weld pics

I finally got the right welder (had to send the first one back) so now I can do some aluminum.

http://www.readywelder.com/10000adp.php

It will not only attach to my MM210 welder as a spool gun for aluminum but it is also fully portable for trail repairs

By they way Happy Birthday!! (I hope I got that right..)

Attached Thumbnails

• 
• 
• 
• 

[craig333]

Nice looking welds. Love to get a ready welder if I ever have the funds. Been lucky enough so far when I needed welding there was always someone else along with a welder.

[Brandon]

I've left messages with both AT and FW and neither one got back to me - guess they are busy! I'll get ahold of them eventually but a bit disappointed neither one got back to me. Looking for where to get the replacement pop up material..

[chnlisle]

Brandon,
These guys have everything and just might have it already cut to size.
http://www.seattlefa...m/products.html